Description: 用双线性变换法设计IIR数字滤波器
滤波就是将外界干扰的不需要的频率滤除掉，一面影响要测试数据的结果。比如如果是心电波的话，如果这是外界有很大的噪声干扰，滤波就是把不必要的信号给抑制掉，以便对心跳的正常测试。通过图比较，滤波后的明显比之前的要平滑，就是滤去干扰噪声的结果。采样间隔对实验有影响，取的过大会导致频率混叠。-Bilinear transformation method using digital filter IIR filter design is to outside interference filter out unwanted frequencies, while the impact to test data results. For example, if it is so heart waves, if this is a great noise outside interference, filtering is unnecessary signal out to the curb in order to test the normal heartbeat. Through chart comparison, after filtering than before to smooth the noise interference is the result of least squares. Sampling interval of the experiment affect take-off frequency of the General Assembly leading to aliasing. Platform: |
Size: 1024 |
Author:果法 |
Hits:
Description: 按照给定指标采用模拟低通滤波器（巴特沃思低通）去逼近理想模拟低通滤波器 ，然后通过双线性变换法对模拟滤波器进行数字化，得到数字滤波器 。-Indicators in accordance with a given analog low-pass filter (Butterworth low-pass) to approximate the ideal analog low-pass filter, and then through the bilinear transformation method of digitizing analog filters, the digital filter. Platform: |
Size: 2048 |
Author:李文嘉 |
Hits:
Description: 用冲激响应不变法和双线性变换法设计IIR的MATLAB程序-Impulse response using the same method and bilinear transformation method of the MATLAB program design IIR Platform: |
Size: 8192 |
Author:s.y |
Hits:
Description: 录制一段自己的语音信号，并对录制的信号进行采样；画出采样后语音信号的时域波形和频谱图；给定滤波器的性能指标，采用窗函数法和双线性变换设计滤波器，并画出滤波器的频率响应；然后用自己设计的滤波器对采集的信号进行滤波，画出滤波后信号的时域波形和频谱，并对滤波前后的信号进行对比，分析信号的变化；回放语音信号；最后，设计一个信号处理系统界面。-Section of their own voice recording signal, and recording the signal sampling draw sample after the speech signal time-domain waveform and frequency spectrum given filter performance indicators, using a window function method and bilinear transformation design of filters, and draw the frequency response filter then use the filter of their own design for the signal acquisition filtering, after filtering the signal to draw the time-domain waveform and spectrum, and filtering of signals before and after contrast, analysis of signal changes playback voice signal Finally, the design of a signal processing system interface. Platform: |
Size: 143360 |
Author:joe |
Hits:
Description: matlb编写的IIR滤波器程序，按照给定指标采用模拟低通滤波器（巴特沃思低通或者切比雪夫低通）去逼近理想模拟低通滤波器 ，然后通过双线性变换法对模拟滤波器进行数字化，得到数字滤波器 。-IIR filter matlb prepared by the procedure, according to set targets and analog low-pass filter (Butterworth low-pass or low-pass Chebyshev) approximation to the ideal analog low-pass filter, and then through the bilinear transformation method for analog filtering device to digitize, the digital filter. Platform: |
Size: 1024 |
Author:李淡 |
Hits:
Description: 基于双线性变换法的IIR滤波器范例 该滤波器为低通原型 可根据需要自行转换成高通 带通 以及重叠累加和重叠保留的例子-Based on the bilinear transformation method of IIR filter for an example of the low-pass prototype filter can be converted to high-pass band-pass as well as the cumulative overlap and overlap to retain examples of Platform: |
Size: 2048 |
Author:yang rui |
Hits:
Description: 使用opencv实现对图像的放大缩小任意倍数，用的双线性插值。-Opencv to realize the use of images of arbitrary multiples of zoom, and use bilinear interpolation. Platform: |
Size: 15360 |
Author:Ma xianzhe |
Hits:
Description: 按照给定指标采用模拟巴特沃斯低通滤波器去逼近理想模拟低通滤波器 ，然后通过双线性变换法对模拟滤波器进行数字化，得到数字滤波器 -Indicators in accordance with a given analog Butterworth low-pass filter to approximate the ideal analog low-pass filter, and then through the bilinear transformation method of digitizing analog filters, digital filters have been Platform: |
Size: 1024 |
Author:凌丽 |
Hits:
Description: 基于matlab实现的双线性变换法设计滤波器，对心电图滤波，得出幅频特性图-Matlab based on the realization of the bilinear transformation method designed filter, for filtering electrocardiogram obtained amplitude-frequency characteristic map Platform: |
Size: 5120 |
Author:秦承峰 |
Hits:
Description: 自己做的：
（一）用双线性变换法设计并用实验系统实现一个三阶的契比雪夫Ⅰ型低通数字滤波器，其采样频率Fs =8KHz，1DB通带边界频率为fp=2KHz。
（二）用双线性变换法设计并用实验系统实现一个三阶的契比雪夫Ⅱ型高通数字滤波器，其采样频率Fs =16KHz，阻带边界频率为fst =4KHz，As=20dB。
-(A) design using the bilinear transformation method and the experimental system of a third-order Chebyshev low-pass type Ⅰ digital filter, the sampling frequency Fs = 8KHz, 1DB passband boundary frequency is fp = 2KHz. (B) Bilinear transformation method used to design and use of the experimental system of a third-order Chebyshev type Ⅱ high-pass digital filter, the sampling frequency Fs = 16KHz, stopband boundary frequency fst = 4KHz, As = 20dB. Platform: |
Size: 14336 |
Author:lanseiboy |
Hits:
Description: 本实验首先按照给定技术指标采用模拟低通滤波器（巴特沃思低通滤波器）去逼近理想模拟低通滤波器，然后通过双线性变换法对模拟滤波器进行数字化，得到数字滤波器。-In this study, first of all technical specifications in accordance with a given analog low-pass filter (Butterworth low-pass filter) to approximate the ideal analog low-pass filter, and then through the bilinear transformation method of the digitization of analog filters, digital filters are . Platform: |
Size: 24576 |
Author:cuiqida |
Hits:
Description: 设计一个IIR数字低通滤波器， 逼近一组模拟滤波器的指标参数（通带截止频率Wp=2*pi*2000rad/s,阻带边界频率Ws=2*pi*3000rad/s,通带波纹 Rp=3db, 阻带衰减Rs=15db, 采样频率f=10000Hz）； 分别用脉冲响应不变法和双线性变换法实现设计，列出传递函数并描绘模拟和数字滤波器的幅频和相频响应曲线。用上述设计滤波器完成几组给定信号的滤波，证明滤波器的有效性和滤波范围限制.-Design a IIR digital low-pass filter, approaching a group of analog filters indicator parameters (pass-band cut-off frequency Wp = 2* pi* 2000rad/s, stop-band edge frequency Ws = 2* pi* 3000rad/s, pass-band ripple Rp = 3db, stop-band attenuation Rs = 15db, the sampling frequency f = 10000Hz) were used to change the impulse response method and bilinear transformation method for design, list and describe the transfer function of analog and digital filter amplitude-frequency and phase-frequency response curve. A filter was designed with the completion of the above-mentioned groups of a given signal filtering, to prove the effectiveness of filters and filter limit Platform: |
Size: 71680 |
Author:刘文珍 |
Hits:
Description: 基于 MATLAB 的语音信号分析与处理的课程设计.录制一段自己的语音信号，并对录制的信号进行采样；画出采样后语音信号的时域波形和频谱图；给定滤波器的性能指标，采用窗函数法或双线性变换设计滤波器，并画出滤波器的频率响应；然后用自己设计的滤波器对采集的语音信号进行滤波，画出滤波后信号的时域波形和频谱，并对滤波前后的信号进行对比，分析信号的变化；回放语音信号-MATLAB-based voice signal analysis and processing of the curriculum. Record a voice signal itself, and the recorded signal is sampled draw sampled speech signal time-domain waveform and frequency spectrum filter performance given by using window method or the bilinear transformation to design a filter, and draw the filter frequency response then filter of their own design collection of the speech signal is filtered, the filtered signal to draw the time domain waveform and frequency spectrum, and filter the signal before and after comparison, analysis of signal changes playback voice signal Platform: |
Size: 1201152 |
Author:姚梅 |
Hits:
Description: 本程序用C语言编制，可在任何计算机上运行，完成连续系统的传递模型到离散系统传递模型的变换。-This procedure using C language, can be run on any computer, complete delivery model to a discrete system of continuous delivery system transformation model. Platform: |
Size: 11264 |
Author:董毅 |
Hits:
Search - bilinear transformation